Can't login to Nextcloud app after Installation

[DrPhreak]

Hello together, i'Ve installed the latest UBOS-Image in yellow, and also in green release.
That worked really well, also the creating of the NextCloudApp.

But here the problems are starting.

The NextcloudApp doesn't accept the login (user/pass) that's set in the site creating process, AFTER UBOS IS REBOOTED!

Has anyone had a problem like that?

Greetz from Germany

DrPhreak

[j12t]

Not heard of that.

So you installed UBOS, said ubos-admin createsite, specified foobar as admin password, and nextcloud as the app, and after reboot, you cannot log into Nextcloud any more with password foobar?

Did it work before the reboot?

Are you certain you have the correct username?

You can check with

Code: Select all

sudo ubos-admin showsite --admin

.

[DrPhreak]

Not heard of that.

So you installed UBOS, said ubos-admin createsite, specified foobar as admin password, and nextcloud as the app, and after reboot, you cannot log into Nextcloud any more with password foobar?

That's correct

Did it work before the reboot?

Yes it did.

Are you certain you have the correct username?

yes, i've checked a few times! (i've made a new setup about 10Times)

You can check with

Code: Select all

sudo ubos-admin showsite --admin

.

I'll try this next time

[New2UBOS]

I installed UBOS on a raspberry pi 3B+ on the weekend, and I see the nextcloud instance while ssh-ing from my linux mint laptop using sudo ubos-admin listsites. Yet, when I try to use the internet to connect to my localhost (as per the instructions - http://ubos-raspberry-pi2.local) - I received an error message about not being able to reach the site.

Is this because I'm only connected through the ssh terminal?

[j12t]

How are you ssh'ing into the your UBOS device? Use the same hostname and/or IP address for the http address. (This assumes you deployed nextcloud to a site with the same hostname, or hostname *)

[New2UBOS]

I will try again tonight when I get home, but I did not change the hostname, and am using the one supplied by the ubos installation.
I ssh-ed into the pi using a UBOS-STAFF USB and then ssh shepherd@ubos-raspberry-pi2.local
The image I am using is the ubos_green_armv7h-rpi2_LATEST.img

I'll go over the instructions again tonight and take a screen shot of the results